Assemble

All components

1 Housing

2 White insert

3 Device

4 Solar panel

5 Solar panel holder

6 Pawl locks

7 Wire

8 Sticky plate

9 Sticky plate’s straighteners

What else will you need

SIM card – try it first with a cell phone – it should be unlocked (no PIN code demanding) and able to connect to the internet via GPRS.

Pheromone lure

A screwdriver

SIM card

• It is recommended to use a regular SIM card (not a micro or nano one) otherwise you will need an adapter.

• It needs a valid contract with a mobile provider with the possibility to send data via GPRS. This contract has to be activated up front. The transmission of the photos goes through the GPRS and it consumes about 50-60 MB of data transmission per month (with one photo taken per day). So, be sure that the SIM card doesn’t have a limit of data transmission lower than that.

• It has to be unlocked – no PIN code demanding.

• It is recommended to try the SIM card with a cell phone first:

  • the activation – that the SIM card is activated by your mobile provider

  • no PIN code demanding – otherwise unlock it

  • GPRS data transfer – connect to the internet

How to assemble the trap

The housing of the trap is made of corrugated polypropylene – an eco-friendly material, which is 100% recyclable. It is resistant to mechanical damage and atmospheric influences, it is non-toxic and reusable for several years. In case of damage it is possible to move all the electronics into a new housing and vice versa.

1 Take the housing – imprinted numbers facing up.

2 Lift both sides up.

3 Fold the side with no.1 imprinted like it’s shown on the picture.

4 Fold the second part.

5 Take one pawl lock and push it in the hole through both layers. Press as much as possible.

6 Repeat the process and insert all the pawl locks. (All 3)

7 Close one door.

8 Take the white insert.

9 Fold both sides down.

10 Put the white insert into the green housing. Lift the two tabs up. (See the arrows.) Start the device.

11 Put the device between two tabs, facing down. (Be sure it fits well.)

12 Push all together inside the housing.

13 Place one sticky plate (remove the protective foil, place the lure on it) on the bottom of the housing with the sticky side looking up. To avoid folding of sticky plate we suggest to use the two straighteners which are placed on shorter edges of the plate.

14 Close the door. The cable should go through the little hole on top of the door.

15 Place the wire through the little holes at the top of the doors to hang it up on a tree.

16 (Place the solar panel into it’s holder and) screw it on a pillar.

17 Hang up the trap in an appropriate place in a crown, and place the solar panel on a pillar so that it will be exposed to the sun as much as possible.